Operating the device
5.4 Operating RAID systems
SIMATIC IPC647E
64 Operating Instructions, 11/2018, A5E45589180-AA
5.4.3 Operating onboard RAID system
5.4.3.1 Configure the onboard RAID system
If you have ordered a device with an onboard RAID system, the RAID system is already
configured on delivery.
If you subsequently set up an onboard RAID system, you will still have to configure it.
Requirement
● The drives required for the onboard RAID system are built into the device, see:
– RAID1 system: Installation options for drives (Page 63)
Navigation in the firmware of the onboard RAID system
• Select entry (then confirm selection) • Arrow buttons on the keyboard
• Confirm selection • <Return> button
• Back to the previous screen • <Esc> button
Set up the onboard RAID system (Create Volume)
1. Switch on the device or restart it.
2. Immediately after turning on the device, as soon as the message "
Press ESC for boot
options
" appears, press and hold the <Esc> button.
3. From the firmware selection menu, using the arrow keys, select the entry "Device
Management" and confirm your selection.
4. From the "Devices List", select the entry "Intel <R> Rapid Storage Technology".
5. Select "Create RAID Volume".
6. On the next screen, assign a name for the RAID system.
7. Select "RAID Level" and select the entry "RAID1" in the following selection window.
8. Select "Select Disc".
A list of the available drives is displayed.
To Next Page
Loading...
Need help?
General
