9-8
Batch
flexible
, Manual
C79000-G7076-C650-02
Note
You must start BOM from WinCC so that the necessary link can be made.
S With the help of the menu function Configure → Plant data... open the
dialog for plant data and select the Measuring points index card. Select
the menu item New... to read in new measuring points.
S In BOM select the menu function Configure → Take over OS users. If a
user group does not exist it will be created, although user privileges must
be assigned explicitly.
Once you have imported the configuration data from the ES and OS, you
must next, in BOM, configure the equipment information which is still
lacking and which could not be configured with the CFC-editor. You can do
this with the aid of BOM via the ’Configure’ menu. Select the function
’Plant data...’ (see Page 3-40) and then the appropriate index cards
(Apparatuses, AF types, Measuring points...). Here additions to setpoint
values and actual values are absolutely essential. To do make these additions,
proceed as follows:
S In BOM, with the help of the menu function Configure → Plant data...
open the dialog for editing the plant data.
S Select the AF-types index card,
S Select an AF-type and click on Edit...,
S Select the setpoint values index card. Here you must specify Designation,
Type, Unit and Actual-reference. The Actual-reference indicates the
connection between setpoint value and actual value. This has relevance to
the batch data.
S Select the Actual values index card and edit it analogously.
The measuring points which are to be added to the recipe header data for a
recipe are read in from the project data of the OS. You can do this via the
’Measuring points’ index card in the menu’Configure’ ––> ’Plant data’.
Adding to the
configuration data
Project planning with BATCH flexible
To Next Page
Loading...
Need help?
General
