EasyManuals Logo

Siemens SINUMERIK 840C Installation Instructions

Siemens SINUMERIK 840C
1154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1139 background imageLoading...
Page #1139 background image
12 Functional Descriptions 01.99
12.36.7 Error handling
The entry XXX in the log file is the name of the target file i.e. the name of the destination data
block.
Check of the last line
for errors
12.36.8 Configurability of the conversion
The user can control the conversion via the ASCII lists. There is a central configuration file
(CONFIG) and a common list of descriptions file (LIST) for all groups (TEA1, TEA2, TEA4).
The selection of the configuration file and the list of descriptions is carried out via the softkeys
Diagnosis, PC data, Conversion data.
Fig.: Configuration file (CONFIG)
The line ”FILES=” is written by the internal conversion routine i.e. the name of the source file
and the name of the target file are recorded there. These files are required for the switchover.
12–364
© Siemens AG 1992 All Rights Reserved 6FC5197- AA50
SINUMERIK 840C (IA)

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals