Siemens SINUMERIK 840C - Configuration File CONFIG

09.95

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
4–25
SINUMERIK 840C (IA)
4.4.2 Configuration file CONFIG
Any files which are not documented here must not be
edited.
Selection: SK ... ,
PC data
Fig. 4.14
Data format of the The configuration file is stored in ASCII format. It consists of a series of lines of
configuration file up to 80 characters each. Each line consists of a reserved word. Comments be-
gin with the characters // and go on to the end of the line.
Description The configuration file CONFIG contains the parameters for the following as reser-
ved words (words reserved by the system)
S the language
S the operator panel interface
S the format and number of the entries in the alarm logs,
S the priority of the alarms, messages, comments
1)
S the format of the time in the protocols.
4 MMC Area Diagnosis
4.4.2 Configuration file CONFIG
1) Up to SW 2 only