Siemens SINUMERIK 840C - Select General Reset Mode (as from SW 3)

09.95

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
2-3
SINUMERIK 840C (IA)
2.3 Select general reset mode (as from SW 3)
START
NC-ON
Communication
to NCK
Yes
No
General reset
mode display
Yes
No
– Start-up switch on
CSB in position
“Start-up” (1)
– NC ON/OFF
Start-up softkey
Operating area
DIAGNOSIS
Password entry
possible
Yes
No
Operating area
DIAGNOSIS
Operating area
DIAGNOSIS
GENERAL RESET
MODE softkey
Fig. 2.1,
see next page
2 General Reset and Standard Start-Up
2.2 Standard installation and start-up as flowchart (as from SW 3)
08.96