09.95
ï›™
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
13–2
SINUMERIK 840C (IA)
Page Section
Control loop
Current control loop 9.2.1
Position control loop 9.2.5
Speed control loop 9.2.3
Coordinate transformation 12.6
Interface signals, NC-PLC 12.6.6
Operation 12.6.7
Programming 12.6.7
Transformation data set 12.6.3
Transformation parameters 12.6.4
Curve-gearbox interpolation 12.18.5
Block search 12.18.10
Following drive overlays 12.18.8
Following error 12.18.9
Gantry axes 12.18.14.2
Gearbox interpolation chain 12.18.7
Monitors 12.18.11
Programming 12.18.12
Start-up 12.18.13
Status data 12.18.15
Synchronous spindle 12.18.14.1
Variable cascading 12.18.6
Cycles 4.4.7
Cycles machine data 6.13
Cycles machine data dialog (as from SW 3) 5.5
D
Data channels, high-speed 12.28
Configuration 12.28.3
Data blocks 12.28.4
Use 12.28.6
Data backup 11
Diagnoses
MMC area 4
PLC 3.5
Distance coded reference marks 10.4.5
Drift compensation 10.4.2
Drive configuration, machine data dialog 5.4
Drive machine data, machine data dialog 5.4
Drive optimization 10.4.1
Drives
Drive servo start-up application 9
Current control loop 9.2.1
Function generator 9.3
Position control loop 9.2.5
Speed control loop 9.2.3
Following drive 12.18.2.1
Leading drive 12.18.2.1
Machine data (FDD/MSD as from SW 4) 7.3
Diagnosis/service MD (FDD/MSD as from SW 3) 7.4
Feedforward drive MD (SW 3) 7.2
Main spindle drive MD (SW 3) 7.1
Master slave 12.30
Parameter set switchover 12.27
Setpoint smoothing filter 12.14.2
Dwell 12.4
09.01
To Next Page
Loading...
Need help?
General
