Siemens SINUMERIK 840C - Page 131

09.95

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
5–3
SINUMERIK 840C (IA)
Axes
S Name:
The name of the axis appears in this window when NC MD 5680 ff (axis
name) is set. Possible input values are: X–X15, Y–Y15, Z–Z15, A–A15,
B–B15, C–C15, U–U15, V–V15, W–W15, Q–Q15, E–E15.
S Function:
Possible display texts are (when NC MD 5640.7 ff – axis exists–input = yes)
–“Linear” : NC MD 5640.5 ff (rotary axis)
Input = No
–“Rotary”: NC MD 5640.5 ff (rotary axis)
Input = Yes
–“Following” : NC MD 18440.0 ff (axis can be following axis) Input = Yes
–“Facing”: NC MD 5720.1 ff (facing axis) Input = Yes
S Setpoint:
The connection value of the setpoint appears in this window when NC MD
3840.6–7 ff (drive/measuring circuit module number) has been set.
For analog drives: “MC x.x” (Measuring circuit in
measuring circuit modules)
and digital drives: “DIG x.x” or “FDD x.”
S Actual value 1:
The connection value of actual value 1 appears in this window when NC MD
2000.6–7 ff (drive/
measuring circuit module number) has been set.
For analog drives: “MC x.x” (Measuring circuit in
measuring circuit modules)
and digital drives: “DIG x.x” or “FDD x.”
S Actual value 2:
The connection value of actual value 2 appears in this window when NC MD
13880.6–7 ff (drive/
measuring circuit module number) has been set.
For analog drives: “MC x.x” (Measuring circuit in
measuring circuit modules)
and digital drives: “DIG x.x” or “FDD x.”
5 Machine Data Dialog (MDD – as from SW 3)
5.1 General remarks