Siemens SINUMERIK 840C - Page 398

07.97 6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.10 MDs for flexible memory configuration
Number of parameters per tool as from SW 4
60006
Default value Lower input limit Upper input limit Units
10 0
10
32
1 TO
Active
after SK
"Reconfigure
memory"
819 tools with 10 parameters each corresponds to 32760 bytes = approx. 32 KB memory.
The upper input limit depends on the NCK memory capacity (4 or 8 MB memory).
Note: The standard tool management (FB package 1) still uses the values in MD 5019,
bit 0 and 1.
Number of channel-spec. R parameters as from SW 4
60007
Default value Lower input limit Upper input limit Units
700 0 700 1 R parameter
Active
after SK
"Reconfigure
memory"
See functional description of "Flexible memory configuration".
Number of central R parameters as from SW 4
60008
Default value Lower input limit Upper input limit Units
600 0 9 300 1 R parameter
Active
after SK
"Reconfigure
memory"
The upper input limit depends on the number of tools (see MD 60005/60006) and the number
of channel-specific R parameters (see MD 60007).
See functional description of "Flexible memory configuration".
Free remaining memory D-RAM as from SW 4
60009
Default value Lower input limit Upper input limit Units
0 Byte
Active
after SK
"Reconfigure
memory"
Machine data reserved by the system.
Free remaining memory S-RAM as from SW 4
60010
Default value Lower input limit Upper input limit Units
0 Byte
Active
after SK
"Reconfigure
memory"
Machine data reserved by the system.
©
Siemens AG 1992 All Rights Reserved 6FC5197- AA50 6–213
SINUMERIK 840C (IA)