LOCK
PASSWORD
09.95
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
2-12
SINUMERIK 840C (IA)
When the softkeys, DIAGNOSIS, NC DIAGNOSIS, NC START-UP and ENTER
PASSWORD have been pressed, the following display appears:
16:38
JOG PROGRAM RESET
M. No. :1
Chann :1
NC alarms
NC
MA. DAT
PLC
MA. DAT.
CYCLE
MA. DAT.
ENTER
PASSWORD
LOCK
PASSWORD
GENERAL
RESET MODE
MACHINE PARAMETER PROGRAMM. SERVICES DIAGNOSIS
Enter password ****
Fig. 2.3
The password for the NCK area is set in machine data 11. The default value 0
corresponds to password + + + .
Any other value defined in machine data 11 must have four digits.
The value is accepted with the INPUT key and the text “ENTER PASSWORD”
disappears.
The password is reset with the “Lock password” softkey.
If the password has not been set correctly, the message “Password incorrect” ap-
pears.
2 General Reset and Standard Start-Up
2.8 Standard installation short version (up to SW 2)
To Next Page
Loading...
Need help?
General
