07.97 7 Drive Machine Data (SIMODRIVE Drive MD)
7.3.2 Drive MD (data description)
Motor code number
1102
Default value Lower input limit Upper input limit Units
0 0 65 535 –
Active on
Power On
Input of motor order number (machine-readable product designation for Siemens motors). This
number is transferred to the drive in the form of a motor code number. The user does not
need to input a value (see also MD 1106). The following motor data are automatically
transferred from an internal motor table by means of the motor code number:
• MD 1103: Motor rated current (FDD/MSD)
• MD 1104: Maximum motor current (FDD)
• MD 1112: Pole pair number of motor (FDD)
• MD 1113: Torque constant (FDD)
• MD 1114: Voltage constant (FDD)
• MD 1115: Armature resistance (FDD)
• MD 1116: Armature inductance (FDD)
• MD 1117: Motor moment of inertia (FDD/MSD)
• MD 1118: Motor zero-speed current (FDD)
• MD 1130: Motor rated power (MSD)
• MD 1132: Motor rated voltage (MSD)
• MD 1134: Motor rated frequency (MSD)
• MD 1135: Motor no-load voltage (MSD)
• MD 1136: Motor no-load current (MSD)
• MD 1137: Stator resistance cold (MSD)
• MD 1138: Rotor resistance cold (MSD)
• MD 1139: Stator leakage reactance (MSD)
• MD 1140: Rotor leakage reactance (MSD)
• MD 1141: Main field reactance (MSD)
• MD 1142: Starting speed field weakening (MSD)
• MD 1143: Upper speed L
h
characteristic (MSD)
• MD 1144: Gain factor L
h
characteristic (MSD)
• MD 1146: Motor maximum speed (FDD/MSD)
• MD 1400: Motor rated speed (FDD/MSD)
• MD 1602: Maximum motor temperature (FDD/MSD)
Note:
If a valid motor order number cannot be entered in this machine data (e.g. for a motor make
other than Siemens), then all these machine data must be entered manually.
Motor table: MSD motors
Order no. Rated
speed
Motor
code no.
n
rated
in
rev/min
1PH6101-4NF4- x 1500 101
1PH6101-4NG4- x 2000 102
1PH6103-4NF4- x 1500 103
1PH6103-4NG4- x 2000 104
1PH6105-4NF4- x 1500 105
1PH6105-4NG4- x 2000 106
Order no. Rated
speed
Motor
code no.
n
rated
in
rev/min
1PH6107-4NF4- x 1500 107
1PH6107-4NG4- x 2000 108
1PH6131-4NF4- x 1500 109
1PH6131-4NG4- x 2000 110
1PH6133-4NF0- x 1500 111
1PH6133-4NF4- x 1500 112
© Siemens AG 1992 All Rights Reserved 6FC5197- AA50 7–83
SINUMERIK 840C (IA)
To Next Page
Loading...
