Siemens Sinumerik 840D Series - Page 281

10.03
Index-281
 Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
L
Loaded valve data, 3-54
M
Machine configuration, 3-49
Machine data groups, 3-91
Machine guideway
Friction, 1-18
Guide, 1-18
Mains connection, 5-184
Manipulated variable inversion, 4-132
Manipulated voltage limitation, 4-132
Manipulated voltage output, 4-124
Measurement function
Measurement of velocity controller, 3-78
Position control measurement, 3-82
Valve control loop measurement, 3-77
Measuring system, 5-178
Measuring system data
Absolute, 3-58
Incremental, 3-58
Mechanical design of drive, 4-137
Modify drive machine data, 3-52
Monitoring
Limit frequency reached measuring
circuit, 4-153
Measuring Circuit, 4-152
Power On alarms, 4-152
Monitoring functions, 4-152
Mounting the HLA closed-loop control plug-in
module, 2-29
Mounting/supply data
Connection, 3-57
Drive data, 3-57
Supply unit, 3-57
N
Natural frequency, 2-42
Natural frequency of hydraulic drive
Possible dynamic response, 2-42
Servo gain, 2-42
Notes
Hotline, 8-238
Technical Support, 8-238
O
Objective, 1-15
Offset adjustment
Offset of pressure sensors, 3-64
Offset of valve manipulated voltage, 3-65
Reference value for pressure sensors, 3-65
Output voltage range of the DAC output, 5-183
Overview of functions of HLA firmware, 4-97
Overview of hydraulics module start-up
process, 3-49
P
Parameter set changeover, 4-98
Position adjustment, 3-67
Position measuring system, 1-19, 4-140
Actual position value, 4-144
Linear scale graduations, 4-142
Phase error compensation, 4-141
Possible dynamic response, 2-42, 4-95
Power disable, 4-149, 4-150
power enable, 4-149
Power supply
external, 2-45
Internal, 2-45
Preset unlisted valve, 3-55
Pressure sensing system, 4-145, 5-179
Offset adjustment, 4-145
Sensor adjustment, 4-145
R
Reference model, 4-111
Referencing data for HLA
Piston zeroing, 3-67
Position adjustment, piston position, 3-67
References, D-261
Relative air humidity U, 5-185
Requirements of external 26.5 V supply, 2-45
S
Selection of servo solenoid valves
Fail-safe position, 2-35
Flow characteristic
asymmetrical, 2-34
Knee-shaped, 2-33
Linear, 2-33
HR servo solenoid valves, 2-33
Pin assignments, 2-35
Preferred range of servo solenoid valves, 2-36
Servo solenoid valve, 2-33
Valve size, 2-33
Valve types, 2-32
Selection of shutoff valves
General, 2-39
Preferred range of shut-off valves, 2-41
Index
10.03