Data and command errors Error code
[errorCode]
Add info
[errorAd‐
dInfo]
Description
9511 Write protection enabled
9520 Increment between calibration digits too small
9521 Sequence of calibration points is not correct
9522 Calibration not yet complete
9523 Calibration digits out of valid range
9524 Calibration weight is 0
9527 Command not permitted in simulation mode
9519 No test operation
6054 Scale command error 6054 Command from the Scale commands group (Zero, Tare, etc.) could
not be executed. Additional information contains details.
9500 Fault present
9501 No stability
9502 Waiting for stability
9507 Dosing active
9515 Not permitted in this weighing operating mode
9530 Current weight is out of defined tare weight range
9531 Current weight is out of defined zero setting range
6055 Weighing command
error
6055 Command from the Weighing commands group (Start single weigh‐
ing, Start continuous mode, etc.) could not be executed. Additional
information contains details.
9500 Fault present
9501 No stability
9502 Waiting for stability
9508 Dosing is not active
9509 Time not permitted within dosing
9513 Service mode is still active
9515 Not possible in this weighing operating mode
9539 Total set point already reached
9540 Current weight is already above fine shut-off point
9542 Set point too small
9543 Set point too large
9544 Tolerance limits implausible
9545 Relation between fine/trailing weight and set point does not fit
9546 Dosing would result in overfilling
9547 Automatic emptying settings (DR25) are not plausible
9548 No check stop defined
9549 Scale is already empty
9555 Jogging time is set to 0 in DR22
6056 Error trace/ protocol/
logging command
6056 Trace, logging or logbook command was rejected. Additional infor‐
mation contains details.
Interrupts/diagnostic messages
9.4 Operating errors
Technology module TM SIWAREX WP351 HF
134 Operating Instructions, 01/2020, A5E47521010-AA
To Next Page
Loading...
Need help?
General
