Simex multicon cmc-99 - Page 85

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
see
Fig. 4.8
Fig. 7.42. The view of a sample list of available hardware inputs for a device
In the device there are two methods to change the source configuration of the
Built-in inputs
:
•
using
Configure source
button in
Logical channel
menu in
Hardware
input
mode,
•
using the
Built-in inputs
menu,
The
Source
for
Hardware input
mode can be (in the same order as list in the device - see
Fig. 7.42
):
a) installed
input modules
in the appropriate slots A, B or C (see
Fig. 4.8
) - the list of
currently available modules is on the website,
Description of input modules parameters is shown in
Chapter 7.9.2. Built-in inputs - Input
modules
.
The following steps change the
Source configuration
for the sample of 3 modules shown in
Fig. 7.43
:
– Step
(1)
- selection of
Source
for channel in
Hardware input
mode, for example:
Inp.A1:Current
, next press the
Configure source
button to enter
Source
configuration
menu,
– Step
(2)
- press the
Mode
button to change range of the current input,
– Step
(3)
- choose from the list of available options for signal range - for example:
Current 0-20mA
(for current module),
85
Slot A, Input 1
Slot X (built-in slot)
Input 4
I16 Module
16 current inputs
Built-in binary input
Built-in Demo input
i