116
Installing the NTS mounting plates on the Guide Rail
There is one mounting plate for each NTS magnet set. These plates are installed on the backside
of the guide rail using the supplied clamps.
The clamps should be slid all the way against the outside edge of the rail for the best support.
The magnet surface plate should be facing outward towards the car, providing a smooth
surface for magnet placement. Make sure the plate can accommodate the magnet placement
in regards to the sensor placements.
V3 Terminal Label Descriptions
Top Terminal
DIN Rail UET UT1 UT2 UT3
Description UETS UNTS1 UNTS2 UNTS3
Bottom Terminal
DIN Rail DET DT1 DT2 DT3
Description DETS DNTS1 DNTS2 UNTS3
To Next Page
Loading...