91
BRAKE BOARD REPLACEMENT
The Small Brake board is mounted on the rail directly below the Drive.
1. Turn off the controller main disconnect power.
2. With power removed, remove the 6-terminal plug on the brake
board.
3. Remove the 4 screws attaching the brake board to the rail.
4. Install the new brake board on the rail and attach re-install the 4
screws.
5. Plug in the 6-pin connector on the brake board.
The Large Brake board is mounted on the rail directly below the Drive.
1. Turn off the controller main disconnect power.
2. With power removed, remove the 6-terminal and both 2-terminal
plugs on the brake board.
3. Remove the 4 screws attaching the brake board to the rail.
4. Install the new brake board on the rail and attach re-install the 4
screws.
5. Plug in the 6-terminal and both 2-terminal plugs back on the
brake board.
To Next Page
Loading...