169
ADJUSTING UP/DOWN STOP POINTS METHOD
NOTE: BE SURE RELEVELING IS TURNED OFF BEFORE
ATTEMPTING TO ADJUST THE FLOOR LEVELS.
Navigate to MAIN MENU | SETUP | FLOOR LEVELS | RELEVELING and set it to
“NO”. Make sure to turn it back on after all floor levels have been set.
UP STOP POINTS
1. To modify the car’s height going UP into a floor (B + ##) navigate to MAIN
MENU | SETUP | FLOOR LEVELS | UP STOP POINT and scroll to the floor
number to adjust. Change the step value to raise or lower the car’s floor level
with the landing level.
a. If the cars floor is too high going up into the landing lower the B + ##
value – (1 step = 3/16”). If the car is too low going up into the landing
raise the B + ## value.
DOWN STOP POINTS
1. To modify the car’s height going DOWN onto a landing (T – ##) navigate to
MAIN MENU | SETUP | FLOOR LEVELS | DOWN STOP POINT and scroll to
the floor number to adjust. Change the step value to raise or lower the car’s
floor level with the landing level.
a. If the cars floor is too high going down into the landing raise the T – ##
value – (1 step = 3/16”). If the car is too low going down into the
landing lower the T – ## value.
The illustrations on the next two pages show the position of the car in relation to
the floor landing. Adjustments will be made depending on direction of travel.
If the car is going UP into a landing then the value to change will be that landing’s
UP STOP POINTS (B + #).
If the car is going down into a landing then the value will be that landing’s DOWN
STOP POINTS (T - #).
The value to change is determined by where the car stops at the landing.
NOTE: BE SURE RELEVELING IS TURNED ON WHEN FINISHED
ADJUSTING THE FLOOR LEVELS.
Navigate to MAIN MENU | SETUP | FLOOR LEVELS | RELEVELING and set it to
“YES”.
To Next Page
Loading...