Smartrise F220

182
PRESSURE TEST (HYDRAULIC SYSTEM):
1. Ensure that the MAIN MENU | SETUP | MISC | BYPASS TERM LIMIT is still
set to “Yes”, and run the car on inspection to the top landing. This procedure
ensures the motor’s bypass valve and stop rings operate correctly.
2. In order to test the functionality of the stop ring:
a. Command the Car to the top terminal landing and place in Inspection
MR.
b. Command the car up from the Machine Room and verify the car stops
on the ring.
c. Disable the car bypass terminal limits by going to MAIN MENU |
SETUP | MISC | BYPASS TERM LIMITS and set this parameter to “NO”
and save it.
d. Move the car back down to door zone. If you receive a “Term Limit”
error then go back to MAIN MENU | SETUP | MISC | BYPASS TERM
LIMITS and verify it is saved to “NO”.
3. Place the car in Normal Operation.
4. If experiencing a problem with pressure valve parameter adjustments may
be made by utilizing the following submenu:
a. MAIN MENU | SETUP | TIMERS | UP TO SPEED DELAY : increase or
decrease to allow more or less time for the motor to reach speed
before the controller operates the up valve (UPL).
HYDRO RUPTURE SETUP
1. If you need to setup and adjust the rupture valve you need to move the car
down in a multi-floor run at the highest speed possible.
a. If your Contract speed is < 150fpm then you can increase your inspection
speed to 150fpm and run it the car on Inspection.
b. If your Contract speed is > 150fpm then you have to run the car in
Normal mode. You can place car calls using MAIN MENU | DEBUG |
ENTER CAR CALLS