Smartrise F220

19
BYPASS TERM LIMITS
(Check off box when complete)
 Toggle the Inspection/Normal switch to the “INSP” position.
 Set BYPASS TERM LIMITS to YES:
 On the Smartrise Machine Room controller board, press the Left
Arrow (ESC) button several times to get to the MAIN SCREEN.
 Press the Right Arrow to go to MAIN MENU. Use the Up / Down
Arrow keys and move the asterisk to SETUP and press the enter
key.
o
Use the Up / Down Arrow keys and move the asterisk to MISC
and press the enter key.
BYPASS TERM LIMITS should be the first item listed. If it’s not, use
the Up / Down Arrow keys and move the asterisk to BYPASS
TERM LIMITS and press the enter key.