100
DOOR ZONE MAGNET INSTALLATION – TAPE
Refer to “DZ1/DZ2 Magnet Placement Illustrations” on the
following pages.
Measuring magnet placement (using paper jig)
1. From the cartop, level the elevator to the Landing and then gain
access to the tape.
2. Place the paper jig (packaged with IP8300 selector) across the top
of the IP8300 tape selector guide rails. Mark a line on the steel
tape at the top of the selector.
3. Move the car down to expose the tape enough to align the top of
the paper jig with the scribed line.
4. Fold the paper jig around the steel tape with the numbered side
facing out and the “LEV” marking at the top aligned with the mark
you made in Step 2. Mark a line on the tape at the 6” mark on the
paper jig.
5. Secure the 6” DZ1 magnet to the steel tape at the mark you made
in Step 4 so that the magnet is slightly covering the holes.
Measuring magnet placement (No Jig)
1. From the cartop, level the elevator to the floor (Landing) to access
the tape.
2. Place a mark on the tape along the top of the selector.
3. Move the car down until the top of the selector is at least 18”
below the line you made in Step 2.
4. Put a mark 8.5” down from the line you made in Step 2.
5. Place the black 6” DZ1 magnet to the steel tape at the mark you
made in Step 4.
6. Place the light yellow 6” DZ2 magnet below the DZ1 magnet
based on the installation type (traction or hydro)
To Next Page
Loading...
Need help?
General
