184
NORMAL LIMIT TESTING SETUP
Special Note:
When testing the limits at the top landings the car should be empty to
provide the proper speeds.
When testing the limits at the bottom landings the car should be fully
loaded to overcome the counterweight and provide the proper speeds.
SPEED PROFILES:
During the various testing procedures certain speeds of your car may
have to be adjusted. These speeds are located in profiles labeled S1, S2,
S3…S8 and are usually different for every job. These profiles are located
in MAIN MENU | SETUP | SPEEDS & SLOWDOWNS.
Use the following chart to record your car speeds.
MAIN MENU|SETUP|SPEEDS & SLOWDOWNS|S1…S8 MAIN MENU|SETUP|SPEEDS & SLOWDOWNS
S1 Speed: _____ FPM Contract Speed: _______FPM
S2 Speed: _____ FPM Inspection Speed: _____ FPM
S3 Speed: _____ FPM Leveling Speed: _______FPM
S4 Speed: _____ FPM
S5 Speed: _____ FPM Top Speed Profile = S__
TOP SPEED PROFILE:
The following tests require changing values in the Top Speed Profile (hereafter
referred to as “S#”) determined from the table above. The Top Speed Profile will
be whatever “S” speed that matches the Contract Speed.
Example:
S3 Speed = 350FPM
Contract Speed = 350FPM
S3 is the profile that will be used for S#
To Next Page
Loading...