203
14. Turn off DIP Switch #1.
15. On the SRU go to MAIN MENU | SETUP | DOOR SETUP | NO DEMAND DO to
“NO” and SAVE it.
16. Set the car back to Normal Operation mode. The car should correct to the
floor.
RACK AND PINION DROP TEST
Setup
1. Move car to top landing
2. Pick the brakes by:
a. Install a jumper wire between 120 and SF1 on the Din Rail.
b. Install a jumper wire between M24 and A1 of the Pick relay.
c. Install a jumper wire between REF and A2 of the Pick relay.
Testing
1. Manually press in the M and B contactor. This will allow the car to drop.
2. When the car reaches the over speed threshold it will trip the over speed
device, and the car should come to a stop.
3. The Smartrise controller should register a governor fault at this time.
Restore
1. Install a jumper wire between M24 and the Governor input
a. Refer to the drawings – Sheet 2 or the supplied IO sheet located in the
binder for the location of the Governor input.
2. Put the car into MR Inspection mode and run the car up 8” or so to unlock
the over speed device.
3. While still in MR Inspection move the car down until the top of car can be
accessed.
4. Reset the over speed device located on top of the car.
5. Remove previously installed jumpers:
a. M24 and the governor input
b. 120 and SF1 on the Din Rail
c. Pick Relay:
i. M24 to A1
ii. Ref to A2
6. Turn off MR Inspection Mode
To Next Page
Loading...