251
Group or Hall Network Comm Down
Check to see if group is communicating with car on (GN+/-). Check to see if Simplex SRU is
communicating with the Hall Network on (HN=/-). Check for loose wiring or missing shield.
Reset any installed features that are limiting car speed.
Reset tripped smoke sensor; check for loose wiring on MR board.
Alert indicating the Lobby Fire Key is on.
Alert indicating Remote Fire Key is on.
Car corrected position on DZ magnet
Monitor travel of car at DZ magnet. Check for overspeed at DZ.
If you received this error after a software upgrade then go to Main Menu | Debug | Adjust
Parameters and change 13-097 from x00 to x04.
Door open signal not made up when expected
Check for loose wire or intermittent switch contacts on DOL sensor.
Max calls for light load, max stops without PHE
Stopped outside of door zone
Car has stopped outside of door zone. Check safety string.