254
1. Auto Operation
a. (Inputs) Enable All CCBs, Independent Service, Light Load, Enable All
HCBs, Door Hold, EMS IC Key, Chime Enable, Sabbath Enable, Attendant
Enable, Attendant Up Button, Attendant Down Button, Attendant Bypass
Button, Car To Lobby, Swing Operation
b. (Outputs) PI 1~8, Hall Lantern Up A~D, Hall Lantern Down A~D, Travelling
Up, Travelling Down, Emergency Power, PI 9, In-Car Buzzer, Passing
Chime, EMS IC Lamp, Sabbath Lamp, Disable PHE, Attendant Hall Call
Above, Attendant Hall Call Below, In Service
2. Doors (Front)
a. (Inputs) GSW (1,2), DCL, DOL, PHE, Mechanical SE, DZ, DCB, DOB
b. (Outputs) Closer, Open, Nudge, Run/DCP, Hall Lock Cam, Restrictor,
Heavy Door, Door Hold Lamp, Car Lantern Up, Car Lantern Down
3. Doors (Rear)
a. Same as Doors (Front)
4. Fire/Earthquake
a. (Inputs) Smoke 1~4, Phase2 Hold, Phase2 Off, Phase2 On, Call Cancel,
Remote Key, Seismic, Counterweight, EQ Reset, Fire Stop Switch, On
Emergency Power, EP (Emer Pwr) Up to Speed
b. (Outputs) Fire Lamp IC, Fire Lamp Lobby, Earthquake Lamp, Fire Phase I,
Fire Phase II, Fire Main, Fire Alt, Shunt Trip, Doors Open @ Lobby
5. Inspect/Access
a. (Inputs) Inspection MR Enable (1,2), Inspection MR Up, Inspection MR
Down, Inspection CT Enable (1,2), Inspection CT Safe, Inspection CT Up,
Inspection CT Down, Access Enable (1,2), Access Bottom Up (1,2), Access
Bottom Down (1,2), Access Top Up (1,2), Access Top Down (1,2),
Inspection IC Enable (1,2), Inspection IC Safe, Inspection IC Up, Inspection
IC Down
b. (Outputs) On Inspection
6. Controller
a. (Inputs) Brake Pick, Viscosity, Battery Power, B Cont NO (Normally Open), B
Cont NO (Normally Open), M Contactor NC, SF1 Relay NC, SF2 Relay NC, DP1,
DP2, Pos Ref Switch, Drive Ready, Drive Fault, E-Brake RGM, E-Brake RGP, E-
Brake DZM, E-Brake DZP, Limit Speed, Go OOS, Shift Data, Shift Reset, Shift
Clock,, SPLD Relay NC, ECO Relay, B2 Cont NO (Normally Open), Drive Enable
b. (Outputs) SF1 Relay, SF2 Relay, SM Relay, Relay UPH, Relay UPL, Relay
DNH, Relay DNL, Brake Pick, Brake Hold, Drive Fault Reset, Drive Field
Enable, Drive Run Up, Drive Run Down, Drive S0~S3, Relay RGM, Relay
RGP, Relay DZM, Relay DZP, Fan/Light, Brake Relevel, Drive Run,
ECO/NCO Relay, SPLD Relay, S-Curve, Shift Reset, Shift Clock, Shift Data,
On Main Line, On Battery, R Relay, S Relay
To Next Page
Loading...