275
7. Per Floor Options – Floor # is the floor selected for security options
a. Floor # (F)/(R) 24/7 (Yes/No)
i. This will activate the specific floor’s security 24hours/day – 7 days/week.
b. Floor # (F)/(R) Timed (Yes/No)
i. This allows security for the specific floor to be active for a set period of time
(see section 6).
c. Access Code
i. This is a 4 digit code that is programmable based on the car call buttons. For
example, a 2-stop car will only be able to use CCB1 & CCB2 for the 4 digit
code where a 5-stop can use any combination of the 5 CCB’s for the code.
ii. Examples;
1. 2-stop, Floors G & 1 – Code can be any combination of the 2 car call
buttons (for example: “G 1 G 1”).
2. 5-stop, floors B, L, 1-3 – Code can be any combination of the 5 car
call buttons (for example: “L 2 1 B”).
Programming Example 1: (4-stop, L, 1-3, front opening) – 24/7 lockout with card reader in car
1. Start by wiring in the CCE inputs on the COP to the card reader – one side of the card
reader to 24vdc and the other side to the CCE input.
2. Go to MAIN MENU | SETUP | SECURITY | PER FLOOR OPTIONS | FLOOR # and choose the
2
nd
floor for security (in this case floor 1) “Floor 1 (F) 24/7”, change to “Yes”. Scroll to the
right to “Save” and press enter.
3. Go to MAIN MENU | SETUP | SECURITY | ENABLE CC LOCKOUT and change to “Yes”. Scroll
to the right to “Save” and press enter.
4. Floor 1 will be locked out until the CCE for floor 1 is activated with card reader.
Programming Example 2: (4-stop, L, 1-3, front opening) – 24/7 lockout with Access Codes
1. Go to MAIN MENU | SETUP | SECURITY | PER FLOOR OPTIONS | FLOOR # and choose the
2
nd
floor for security (in this case floor 1) “Floor 1 (F) 24/7” and change it to “Yes”. Scroll
to the right to “Save” and press enter.
2. In the Floor # menu choose “Access Code (F)” and change to whatever 4-digit code you
want assigned for this floor using the car call buttons. For this example we’ll use “L 2 2
1”. Scroll to the right to “Save” and press enter.
Note: The default code is the bottom landing PI as all 4 digits (In this case: “L L L L”).
** You cannot leave it at the default as this will disable the code. **
3. Select “Enable CC Lockout” change to “Yes”, scroll to “Save” and press enter.
To operate the Access Code feature, press the button for the secured floor. When
the button starts flashing, type in the 4-digit code for that floor. The car will latch
the car call when the correct code is entered.
NOTE FOR 2-BOARD SYSTEMS ONLY: If Access Code isn’t working, go to MAIN MENU | DEBUG |
ADJUST PARAMETERS and change 00-111 to “x01”. Cycle the main disconnect and retry the
security feature.
To Next Page
Loading...