77
KEB PROGRAMMING MENU
The programming menu is where all manual parameter adjustment is made and
can be accessed at Home > Prog (F3).
The Parameter menu contains the following groups:
Operator System: OS00...OS22
These parameters provide general information about the operator and drive
hardware and software. Additionally, the operator password level is set here which
allows for different access levels.
Basic Setup: US02...US06
These parameters provide the very basic information needed to configure the
drive, including: motor type, control type, and contract speed.
Inputs: LI01...LI20
These parameters define the logic of the inputs and assign control functionality to
the digital inputs.
Motor Data: LM01...LM33
These parameters define and display all relevant motor values and motor
protection settings.
Encoder Data: LE01...LE36
These parameters define the settings and scalings of the drive encoders
Machine Data: LN01...LN05
These parameters define the machine data, including: sheave diameter, roping
ratio, and rated load values.
Speed Profile: LS01...LS55
These parameters adjust the speed, acceleration, and jerk values across the
elevator run profile.
Tune Parameters: LL01...LL17
These parameters contain the automatic tuning parameters. Here you can program
the system inertia, motor data, and motor pole positions.
To Next Page
Loading...