DMS-1200 Release 6 Operations Manual
Section 4 – DMS-1200 Setup 35
b. If the BIU does not appear on the Unassigned list, click Add. Enter the BIU IP address. Then
click Apply.
3. Check the communication Status. Green indicates a working connection is established.
The system populates the BIU Name and Serial Number fields.
You can see the BIU topology (other DAS components connected to a particular BIU) by
clicking on the BIU hyperlinked name in the BIU field.
4 To delete a BIU from the Assigned list, click the red X in the Remove column.
5. To view the IP and Port settings for each BIU, click the Remote Access tab.
These settings can be edited from the Network > System menu. (See
Setting the DMS IP
Addresses on page 28.)
To Next Page
Loading...