DMS-1200 Release 6 Operations Manual
Section 7 – DAS Device Control 50
7 DAS Device Control
The DMS-1200 supports several functions for monitoring and controlling the DAS devices:
• Initial System Commissioning – The initial system commissioning process comes after
hardware installation and prepares the DAS to handle live network traffic. Two methods
are available: setting parameters individually using the device control screens
or using
the automated EasySet process. (See the next section System Commissioning with
EasySet.)
• Ongoing Device Control and Monitoring – Use the Control screens, explained in this
section, at any time to configure existing devices or for new devices added to an
operating DAS.
• Firmware Upgrade – Upgrade device firmware as it becomes available.
• Trend Data – View and download trend data on device performance.
• Inventory Reports – View and download reports on currently installed DAS devices.
• Backup and Restore – Save the current DAS configuration for all devices to a backup
file and restore settings as needed.
In This Section
Using the Device Control Screens
Setting BIU Parameters
Setting ODU Parameters
Setting OEU Parameters
Setting Remote Optic Unit (ROU) Parameters
LROU Setup
MROU Setup
HROU (TiTAN) Setup
NHROU (THOR) Setup
Green Mode Setup
PIMD Level Measurement (HROU Only)
External Alarm Setup (HROU Only)
Upgrading Firmware for DAS Components
Backing up and Restoring Device Settings
To Next Page
Loading...