DMS-1200 Release 6 Operations Manual
Section 7 – DAS Device Control 61
7.5 Setting Remote Optic Unit (ROU) Parameters
The ALLIANCE REL6 system supports three types of remote optic units (ROUs): a low-power 1W
unit (LROU), mid-power 5W unit (MROU), and a high-power 20W unit (HROU or NHROU). In
addition, SOLiD currently supports two 20W remotes: the legacy TiTAN remote (shown as HROU
in the DMS-1200 setup screens) and the THOR remote (NHROU) that was introduced with
ALLIANCE REL6.
Each remote also supports a unique set of remote drive amplifier units (RDUs). Setup for each
type of remote and drive unit varies slightly, and so instructions are divided into separate sections
in this document.
TIP: SOLiD’s recommended settings for all remote units and drive units can be found in the
document: ALLIANCE DAS Tech Note - Commissioning with DMS-1200 available from SOLiD
support.
In This Section
LROU Setup
LRDU Setup
MROU Setup
MRDU Setup
HROU (TiTAN) Setup
HRDU (TiTAN) Setup
NHROU (THOR) Setup
NHRDU (THOR) Setup
Green Mode Setup (THOR NHROU Only)
PIMD Level Measurement (THOR NHROU Only)
External Alarm Setup (NHROU THOR Only)
To Next Page
Loading...