Solid DMS-1200 - Rebooting the DMS Server; Assigning; Removing Bius

DMS-1200 Release 6 Operations Manual
Section 4 – DMS-1200 Setup 34
4.8 Rebooting the DMS Server
After upgrading the DMS software or if any of the DMS functions become unresponsive, reboot
the DMS from the System menu.
1. On the Network menu, click System.
2. Click Reboot. It may take up to one minute for the system to come back online.
TIP: You can also press the Reset button on the front panel of the DMS server to reboot the
system.
4.9 Assigning / Removing BIUs
When you connect the DMS-1200 to the DAS, the DMS should automatically recognize the
system’s BIUs and load BIU information to the Unassigned BIU list. You will need to move
unassigned BIUs to the Assigned BIU list before you can manage the BIU using the DMS-1200.
If a connected BIU is not automatically recognized by the DMS, you can also manually add it to
the Assigned BIU list.
1. On the Network menu, click BIU Setup.
2. Click the Setup tab. Assign the BIU according to these guidelines:
a. If the BIU appears on the Unassigned BIU list, check Use and then click Apply to move it to
the Assigned list.
NOTE: The DHCP IP displayed is the IP automatically assigned to an unassigned BIU. When you
click Apply, a Static IP is assigned so that all BIUs will be arranged in numerical order.