Sony DCR-PC6E - Adjusting Items When Replacing Main Parts and Boards

5-2
Replaced parts
Block replacement Parts replacement
zz
zz
zzzz
zz
zz
zz
zz
zz
z
zz
z
z
zz
zz z
zz
z
z
z
zz
z
zz
zz z z
z
zz z
zz
zz zz
zz zz
zz zz
z
zz
zz
zzz
Lens device Mechanism deck Note Color EVF block LCD902 (LCD panel (EVF)) Color EVF block LED902
(Back light LED (EVF))
LCD block LCD901 (LCD panel (LCD)) LCD block ND901
(Fluorescent tube (LCD))
LCD block Inverter unit (LCD) LCD block Touch panel (TP-1770) Mechanism deck M901 (Drum assy) Note
Mechanism deck M902 (Capstan motor) CF-085 board SE3450/3451
(PITCH/YAW sensor)
PD-148 board IC2101 (RGB driver (LCD)) PD-148 board IC2103 (Timing generator (LCD)) VC-265 board IC1802 (RGB driver (EVF))
VC-265 board IC1803 (Timing generator (EVF)) CF-085 board IC3201 (CCD imager) VC-265 board IC302, X301 (Timing generator) VC-265 board IC303 (CDS, AGC, A/D conv.) VC-265 board IC204 (Lens pre-driver)
VC-265 board IC401 (Camera process, EVR) VC-265 board IC801 (LINE IN/OUT AMP) VC-265 board IC5302 (DV signal process) VC-265 board IC101 (EQ, A/D CONV., PLL) VC-265 board IC102 (REC/PB AMP)
Adjustment
Section
Initialization of
B, C, D, E, F,
7, 8 page data
Camera
Color EVF
LCD
System control
Servo, RF
Video
Mechanism
Adjustment
Initialization of C, D, 8 page data
Initialization of B page data *1
Initialization of E, F, 7 page data
36MHz origin oscillation adj.
HALL adj.
Flange back adj.
Optical axis adj.
Color reproduction adj.
MAX GAIN adj.
AWB & LV standard data input
Auto white balance adj.
Mechanical shutter adj. *1
Angular velocity sensor sens. adj.
VCO adj.
Backlight adj.
Bright adj.
Contrast adj.
White balance adj.
VCO adj.
Bright adj.
Black limit adj.
PSIG gray adj.
Contrast adj.
Center level adj.
V-COM adj.
White balance adj.
Serial No. input
Touch panel adj.
CAP FG duty adj.
Switching position adj.
AGC center level adj.
APC & AEQ adj.
PLL fo & LPF fo adj.
Chroma BPF fo adj.
S VIDEO OUT Y level adj.
S VIDEO OUT chroma level adj.
Tape path adj.
1. Adjusting items when replacing main parts and boards.
• Adjusting items when replacing main parts
When replacing main parts, adjust the items indicated by z in the following table.
Note: When replacing the drum assy. or the mechanism deck, reset the data of page: 2, address: A2 to A4 to “00”. (Refer to “Record of Use check” of “5-4.
SERVICE MODE”)
Table. 5-1-1 (1).