115DME Special Effect Operations
Chapter 11 DME Operations
3
When you select Adaptive Y/C or Adaptive Y in step 2, set the following
parameter.
4
In the <Key Field/Frame Mode> group, select the interpolation method for
the key signal.
Adaptive: Detect changes in the luminance component of the key signal
separately, and switch automatically between fields and frames.
Field: Do interpolation in field units. This gives natural movement,
suitable for moving video.
Frame: Do interpolation in frame units. This gives higher image precision,
suitable for still pictures.
5
When you select Adaptive in step 4, set the following parameter.
6
In the <Interpolation Mode> group, set the number of pixels to use in
interpolation.
Multi: Do interpolation using 8-by-8 pixels. This gives higher picture
quality.
Linear: Do interpolation using 2-by-2 pixels.
Note
When using the BKDS-9470, Multi is always selected.
7
In the <Filter Mode> group, select the method used to show the picture
reduced or expanded.
Mode1: Even when the picture is reduced, add compensation so that it can
be seen clearly.
Mode2: Suppress aliasing when expanding or reducing the picture.
Knob Parameter Adjustment Setting values
1 Mode Degree of motion detection 1 to 4
Knob Parameter Adjustment Setting values
1 Mode Degree of motion detection 1 to 4
To Next Page
Loading...
