45DME Special Effect Operations
Chapter 11 DME Operations
4
Press [H] in the <Invert> group, turning it on, to invert the flex shadow
horizontally.
5
Turn [Size] on and use knob 2 to set the Size V parameter so that the
shadow extends vertically.
6
Press [Skew], turning it on, and use knob 1 to set the Skew H parameter so
that the parallel lines appear to emerge from the depth at the right.
Defocus Settings
This effect defocuses the entire image.
For an illustrative figure and other information, see “DME Special Effects” in
Chapter 1 (Volume 1).
Applying the Defocus effect
Use the following procedure.
1
In the DME menu, select VF2 ‘Video Modify’ and HF1 ‘Defocus/Blur.’
The Defocus/Blur menu appears.
2
Press [Defocus], turning it on.
The Defocus effect is enabled. You can adjust the defocusing of video and
key signals with the knobs.
3
In the <Defocus> group, select the signal to which to apply the defocus
effect.
Video/Key: Video signal and key signal
Video: Video signal only
4
Set the parameters.
• When Video/Key is selected
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
and key signals
0.00 to 100.00
2 V Vertical defocusing of video and
key signals
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video and key
signals
H value shown
To Next Page
Loading...
