375Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Chapter 18 Macros
3
Press the [ENTER] button.
This recalls the specified register.
When you recall an empty register
This assigns the numeric keypad control block and keyframe control block to
macro editing.
For details of macro editing, see “Creating and Editing a Macro” (see below).
When you recall a register holding a macro
This immediately executes the macro. While the macro is executed, the
[RCALL] button flashes.
Notes
• It is not possible to execute more than one macro at a time.
• During macro execution, recalling the same register again stops the macro
being executed.
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing it is not possible to execute a macro.
• While executing a macro using a button with a macro attachment set, it is not
possible to recall and execute a different macro from the numeric keypad
control block.
Creating and Editing a Macro
Use the numeric keypad control block and keyframe control block to create and
edit a macro.
After carrying out creation and editing, be sure to carry out a save operation
(see page 382), using the numeric keypad control block.
Switching auto insert mode on or off for macro creation/editing
In the auto insert mode, when creating or editing a macro, an operation carried
out on the control panel is automatically registered as an event.
When this mode is off, it is necessary to press the [INS] button in the keyframe
control block for each operation to register the event.
To toggle the auto insert mode on or off, press the [AUTO INS] button
assigned to a utility/shotbox control block button or user preference button.
To Next Page
Loading...
