Chapter 18 Macros
372
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Macro Operations in the Numeric Keypad
Control Block and the Keyframe Control
Block
This section describes macro operations carried out in the numeric keypad
control block and the keyframe control block.
Note
For a macro take operation (see “Macro Execution” under “Macros” in
Chapter 1 (Volume 1)), do not use the numeric keypad control block or
keyframe control block. Operate with the take assigned to a utility/shotbox
control block or user preference button. (See “Setting Button Assignments
(Prefs/Utility Menu)” on page 266.)
For an overview of macros, see “Macros” in Chapter 1 (Volume 1).
For macro operations in the numeric keypad control block, use the following
buttons. (See the figure on next page.)
To Next Page
Loading...
