Chapter 11 DME Operations
22
Three-Dimensional Transformation Operations
6
To automatically erase the graphic display while the keyframes are
executing, press the [Auto Erase] button, turning it on, and then set the
following parameter.
Outputting graphics to the monitor output connector
In the Graphic menu, press [Monitor Out] to turn it on.
Graphics are displayed on the device connected to the monitor output
connector.
Canceling Virtual Images
When a transformation is executed with an extreme degree of perspective, the
part of the image which is beyond the imaginary view point can wrap around
and show on the other side. The wrapped-around portion is referred to as a
virtual image.
Using the DME menu, you can make a setting not to show the virtual images.
Canceling virtual images
Use the following procedure.
1
In the DME menu, select VF6 ‘Input/Output’ and HF2 ‘Video/Key.’
The Video/Key menu appears.
2
Press [Wrap Around], turning it on.
The virtual image disappears.
Knob Parameter Adjustment Setting values
1 Recover Time Time until graphic display
appears again after keyframe
execution
0 to 300 (frames)
To Next Page
Loading...
