Chapter 12 External Devices
134
Control of VTRs and Disk Recorders
Control of VTRs and Disk Recorders
VTR and disk recorder operations require the optional MKS-8031TB
Trackball Module.
To control a VTR or disk recorder in this system, the following settings are
required.
• Button assignment: For a VTR or disk recorder connected to the DCU 9-pin
serial port, assign a device selection button in the device control block.
• Timecode source: When using a VTR, specify a reference signal used for
determining the tape position.
For details, see “Making DCU serial port settings” (page 280) and “Making
detailed settings on the external device connected to the serial port” (page
333).
Controlling the Tape/Disk Transport
Switching to VTR/disk recorder operation mode
To control a VTR or disk recorder, press the [DEV] button in the device control
block, turning it on.
This puts the device control block in VTR/disk recorder operation mode, and
the button arrangement changes as shown in the following figure. (Note that
[USER], [RUN CTRL], and [SHIFT] do not operate in VTR/disk recorder
operation mode.)
To Next Page
Loading...
