19Three-Dimensional Transformation Operations
Chapter 11 DME Operations
Viewing the three-dimensional parameter details
In the DME menu, press the menu title button (the [DME] in the upper left part
of the screen).
The Status menu appears. This menu shows the three-dimensional parameters
for the DME reference channel currently selected in the device control block.
Example three-dimensional parameter details
Entering Three-Dimensional Parameter Values
In addition to setting three-dimensional parameter values with the trackball and
Z-ring, you can enter them directly from the numeric keypad control block.
Entering three-dimensional parameter values
Use the following procedure.
1
In the device control block, press the [X], [Y], or [Z] button, turning it on.
The numeric keypad control block enters a mode in which you can enter
parameters for the selected axis.
To Next Page
