Chapter 13 Keyframe Effects
174
Creating and Editing Keyframes
Pause
To apply a pause to a keyframe, use the following procedure.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect on the keyframe to which you want to apply a pause.
3
Press the [PAUSE] button.
This applies a pause to the specified keyframe.
Keyframe Loop (Repeated Execution of a Specified
Range)
By setting the range of the loop within the effect, and the number of loop
executions, you can execute the loop range repeatedly.
Note
It is only possible to set one keyframe loop for each region.
Creating a new keyframe loop
To specify the loop range and loop count, carry out the following procedure.
1
Press the [EDIT ENBL] button, turning it on.
2
Stop the effect on the keyframe you want to make the first of the loop range
(start point). (Here, by way of example, keyframe 2 is taken as the start
point.)
3
Press the [KF LOOP] button in the keyframe control block, turning it on.
The numeric keypad control block display shows the start point keyframe
number as follows.
The example shown means “from (keyframe) 2 to...,” where the end
keyframe is to follow.
FM 2 TO
To Next Page
Loading...
