301Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
Single: Carry out a preset color mix with a single transition operation.
3
In the <Non Drop Key> group, select the key setting for a transition
including a key.
To carry out the transition with the key state maintained, press [Key1] to
[Key4], turning them on. (See “Transition Types” in Chapter 1 (Volume
1).)
4
If each time a transition ends the transition type is to return to the previous
setting, press [One Time Enable].
Settings relating to fader lever operations
To select the way in which the fader lever position and the transition progress
are related, use the following procedure.
1
In the Switcher>Transition menu, press [Transition Curve].
The Transition Curve menu appears.
2
In the <Fader Curve> group, select the fader lever operation mode.
Normal: The transition progress is linear, according to the fader lever
position. (Factory default setting)
Adv Tally Mode: When the fader lever is moved from the end of its travel,
the tally is output slightly before the transition starts.
Settings Relating to Keys, Wipes and Frame Memory
(Key/Wipe/FM Menu)
For settings relating to keys, wipes and frame memory, use the Switcher>Key/
Wipe/FM menu.
To display the Key/Wipe/FM menu
In the Engineering Setup menu, select VF3 ‘Switcher’ and HF5 ‘Key/Wipe/
FM.’
The status area shows the key memory settings, mask and border processing
order, key priority, cross-point hold, pattern limit transition, and wipe edge
settings for each operating bank.
Switching video process memory on or off
In the Switcher>Key/Wipe/FM menu, press [Video Proc Memory], turning it
on. (See also “Switcher Setup” in Chapter 1 (Volume 1).)
To Next Page
Loading...
