327Setup Relating to DCU
Chapter 16 Engineering Setup
• As for “Aux ? O’ride Src ??,” when “Rising Edge” is selected, on a rising edge the
set AUX bus primary input is used. On a falling edge, the original state of the cross-
point is restored. If the GPI trigger is applied repeatedly at short intervals (0.5
second or less), the cross-point switching may not be carried out correctly. In this
case, apply the GPI trigger again.
b) When knob 2 selection is “Key Snapshot”
c) When knob 2 selection is “Snapshot”
d) When knob 2 selection is “Effect”
5
To confirm the setting in step 4, press [Action Set].
This confirms the setting, which appears in the status area.
Carrying out level settings
To set the low level and high level, first set the trigger type to “Level,” then use
the following procedure.
1
In the DCU>GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
Parallel Output Settings (Output Config Menu)
For the DCU parallel output ports, after carrying out tally settings in the
Router/Tally>Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU>Output
Config menu.
Knob Parameter Adjustment Setting values
1 No Signal format/screen aspect ratio
selection
1 to ...
To Next Page
Loading...
