Chapter 16 Engineering Setup
328
Setup Relating to DCU
To display the Output Config menu
In Engineering Setup, select VF5 ‘DCU’ and HF3 ‘Output Config.’
The status area shows output port information.
Assigning a GPI output port
Use the following procedure.
1
In the DCU>Output Config menu, select what the setting applies to (DCU1
or DCU2) from the <DCU Select> group.
2
In the <Parallel Output Assign> group, press [GPI Output].
3
Using any of the following methods, select the output port and GPI output
number.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
4
To confirm the selected setting, press [GPI Output Set].
This confirms the selection, which is reflected in the status area.
Releasing the assignment of a GPI output port
Use the following procedure.
1
In the DCU>Output Config menu, select what the setting applies to (DCU1
or DCU2) from the <DCU Select> group.
2
In the <Parallel Output Assign> group, if [GPI Output] is on, press it to
turn it off.
3
Turn the knobs to select the slot and port to which the setting applies.
Knob Parameter Adjustment Setting values
1 Parallel Output Slot Output port slot 2 to 6
2 Parallel Output Port Output port 1 to 54
5 GPI Output GPI output 1 to 50
Knob Parameter Adjustment Setting values
1 From Slot First port slot 2 to 6
2 From Port First port number 1 to 54
3 To Slot Last port slot 2 to 6
To Next Page
Loading...
