Chapter 11 DME Operations
46
DME Special Effect Operations
• When Video is selected
5
To cancel black level leaking that can occur at the edge of the screen when
the Defocus effect is enabled, press [Clean Defocus], turning it on.
Masking the Defocus effect with a selected pattern
Press [Mask] to display the Mask menu, and set the pattern type and modifiers.
For details, see “Mask Settings” (page 59).
Blur Settings
This effect blurs the entire image.
Applying the Blur effect
Use the following procedure.
1
In the DME menu, select VF2 ‘Video Modify’ and HF1 ‘Defocus/Blur.’
The Defocus/Blur menu appears.
2
Press [Blur], turning it on.
The Blur effect is enabled. You can adjust the blurring of video and key
signals with the knobs.
3
Set the parameters.
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
signal
0.00 to 100.00
2 V Vertical defocusing of video
signal
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video signal
H value shown
Knob Parameter Adjustment Setting values
1 H Horizontal defocusing of video
and key signals
0.00 to 100.00
2 V Vertical defocusing of video and
key signals
0.00 to 100.00
3 All Horizontal and vertical
defocusing of video and key
signals
H value shown
To Next Page
Loading...
