Sony DVS-9000SF - Cross-Point Settings (Xpt Assign Menu)

257Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
To switch the [UNDO] button on a simple type Flexi Pad control block to a
[MCRO] button for macro operation, use the following procedure.
1 In the Engineering Setup menu, select VF2 ‘Panel’ and HF1 ‘Config.’
The Config menu appears.
2 Press the [Program Button].
The Program Button menu appears.
3 Press [Flexi Pad Module].
The Flexi Pad Module menu appears.
4 Select the assignment of the [UNDO] button in the simple type Flexi Pad
control block from the <UNDO Button Assign> group.
Undo: use as an [UNDO] button.
Macro: use as a [MCRO] button.
Cross-Point Settings (Xpt Assign Menu)
To carry out the cross-point settings, use the Panel>Xpt Assign menu.
To display the Xpt Assign menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF2 ‘Xpt Assign.’
The status area shows button numbers of the cross-point buttons, and the
assigned video/key source names, and source name display color.
Assigning signals to cross-point buttons
For each button number, a pair consisting of a video signal and a key signal is
assigned. You can also assign the same signal to another button number at the
same time.
When carrying out key operations on a bank, if the key fill and key source
selection mode is set to [Auto Select], the signals are selected according to this
pair setting. (See “Selecting Key Fill and Key Source” in Chapter 4 (Volume
1).)
To assign a video signal or key signal to cross-point buttons, proceed as
follows.
1 In the Panel>Xpt Assign menu, press [Source Select].
The Source Select menu appears.