287Setup Relating to Operations From the Control Panel
Chapter 16 Engineering Setup
Screen Saver and Other Settings (Maintenance Menu)
To make settings relating to the screen saver, etc., use the Panel>Maintenance
menu.
To display the Maintenance menu
In the Engineering Setup menu, select VF2 ‘Panel’ and HF7 ‘Maintenance.’
The status area shows a list of the items with their settings.
Screen saver settings
To enable the menu screen saver, use the following procedure.
1
In the Panel>Maintenance menu, press [Screen Saver], turning it on.
2
Adjust the following parameter.
Adjusting the brightness
You can adjust each of the following brightnesses independently.
LCD: Adjust the brightness of the source name displays and the LCD buttons
in the Flexi Pad control block.
LED: Adjust the brightness of the LED displays in the numeric keypad control
block and so forth.
Switch: Adjust the brightness of the panel switches.
The following description takes the LCD brightness as an example. Use a
similar process for the other adjustments.
1
In the Panel>Maintenance menu, press [LCD Brightness].
2
Adjust the following parameter.
a) The larger the value, the brighter the screen.
Adjusting the alarms
In the Panel>Maintenance menu, make the following settings.
Knob Parameter Adjustment Setting values
1 Sleep Time Time until screen saver starts
operation
1 to 300 (minutes)
Knob Parameter Adjustment Setting values
1 Brightness Menu screen brightness
1 to 5
a)
To Next Page
Loading...
