Chapter 14 Snapshots
214
Snapshot Operations in the Menus
2
Press the region display in the upper part of the list to display a selection
window, then select the region in the selection window. Selecting multiple
regions is also possible.
3
Press [OK].
The selected region name appears in the upper part of the list.
4
Using either of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
• To select all registers, press [All].
5
In the <Recall Mode> group, select one of the following modes for save
and recall operations.
XPT: Only the key material selection data is saved or recalled.
Modifier: Only the key modifier settings are saved or recalled.
Transition: Only the independent key transition settings are saved or
recalled.
Creating and Saving a Master Snapshot
To save a master snapshot in the Snapshot menu, after recalling the
Snapshot>Master Snapshot>Store menu, refer to the operations in “Creating
and Saving a Master Timeline With the Menu” (page 193).
Recalling the Store menu
Carry out the following procedure.
1
Do either of the following.
• In the menu control block, press the top menu selection button
[SNAPSHOT].
• In the numeric keypad control block, press the [SNAPSHOT] button
twice in rapid succession.
The Snapshot menu appears.
Knob Parameter Adjustment Setting values
1 Register Register number 1 to 4
3 Num Select number of registers 1 to 4
To Next Page
Loading...
