Chapter 19 Color Corrector
396
Color Corrector Functions
secondary color correction set mask 1 to a pattern, this also changes the setting
in primary color correction to the pattern.
Secondary Color Correction Operations
Note
When spot color adjustment is enabled in the setup settings, this function is
disabled. (See “Switching the color correction function” (page 244).)
Applying secondary color correction
Use the following procedure.
1
In the CCR menu, select VF1 ‘CCR1’ and HF3 ‘Secondary CCR.’
The Secondary CCR menu appears.
2
In the <Secondary CCR> group, press [Secondary CCR], turning it on.
3
In the <Secondary CCR Adjust> group, select the color for which you
want to make the setting.
4
Adjust the following parameters.
To return the parameter settings to their default values
In the <Secondary CCR> group press [Unity].
Masking a part of the secondary color correction
In the <Secondary Mask> group, press [Mask1] or [Mask2], turning it on, then
carry out the same operation as described under “Masking a part of the primary
color correction” (page 393).
Knob Parameter Adjustment Setting values
1 Luminance Luminance –100.00 to +100.00
2 Saturation Saturation 0.00 to 200.00
3 Hue Delay Hue –180.00 to +180.00
To Next Page
Loading...
