Sony DVS-9000SF - Page 244

Chapter 16 Engineering Setup
244
Setup for the Whole System
3 Press directly on the name of the software for which you want to cancel the
license registration (the Condition box shows “Active”).
4 Press [License Management].
The License Management menu appears.
5 Press [Deactivate License].
A confirmation message appears.
6 Press [Yes].
A license registration canceled message appears.
7 Press [OK].
The status area Condition box showing “Active” changes to blank.
8 Using either of the following methods, restart the device.
• In the System>Initialize menu, select only the device for which you
registered the license, and press [Reset] in the <Initialize> group.
• Power off and on again.
After restarting, the software for which the license registration has been
canceled is no longer available.
Switching the color correction function
Note
After making the setting, be sure to finally press [Execute] to confirm the
setting. To cancel the setting during the process, press [Clear].
Use the following procedure.
1 In the System>Install/Unit Config menu status area, select SWR1 or
SWR2, where the color correction function is installed.
2 Press [Unit Config].
• The Unit Config menu appears.
• The status area shows the device name and the currently selected color
correction function name.
3 In the <CCR Config> group, select either of the following.
Spot CCR: Enable the spot color adjustment function.