Chapter 11 DME Operations
48
DME Special Effect Operations
• 16:9 mode
a) Specify minus values to stretch the image in the vertical direction, and plus values to
stretch the image in the horizontal direction.
Sepia Settings
This effect overlays a specified color onto the image.
Applying the Sepia effect
Use the following procedure.
1
In the DME menu, select VF2 ‘Video Modify’ and HF3 ‘Color Modify.’
The Color Modify menu appears.
2
Press [Sepia], turning it on.
The Sepia effect is enabled. You can adjust the degree of mixing between
the sepia image and the original image with the knobs.
3
Set the following parameters.
4
To set the color of the sepia image, press [Sepia Color], turning it on, and
adjust the parameters.
Knob Parameter Adjustment Setting values
1 Center X x-value of shrinking center point –4.00 to +4.00
2 Center Y y-value of shrinking center point –2.25 to +2.25
3 Size Shrinking ratio 0.00 to 100.00
4 Aspect Aspect ratio of shrunken images
–100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Mix Y Y signal mix amount 0.00 to 100.00
2 Mix C Chroma signal mix amount 0.00 to 100.00
3 Mix All Y signal and chroma signal mix
amount
Mix Y value shown
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
