97DME Special Effect Operations
Chapter 11 DME Operations
a) The way in which the afterimage disappears is affected by both Decay and Trail Dust
parameter adjustments.
Setting a combine process
Select whether to add the Trail effect before or after the combine.
Notes
• When you change the selection in the <Combine Process> group, the
afterimages which had been added up to then disappear.
• When you do not combine images, the Trail effect only is applied, regardless
of the selection in the <Combine Process> group.
Select one of the following in the <Combine Process> group.
Combine –> Trail: Add the Trail effect after the combine. As the trail
parameters, the data for the channel with the lowest number among the
channels being combined is enabled.
Trail –> Combine: Add the Trail effect before the combine. Trails parameters
can be set independently for each channel.
Motion Decay Settings
When the video image is a moving image, you can blur the motion by creating
motion trails (or afterimages).
For sample images, see “DME Special Effects” in Chapter 1 (Volume 1).
Note
When you turn on motion decay, if the Trail or Keyframe Strobe effect is on,
it automatically goes off.
Combine –> Trail Trail –> Combine
To Next Page
Loading...
