Chapter 11 DME Operations
98
DME Special Effect Operations
Blurring image motion
Use the following procedure.
1
In the DME menu, select VF5 ‘Light/Trail’ and HF3 ‘Motion Decay.’
The Motion Decay menu appears.
2
Press [Motion Decay], turning it on.
This enables motion decay, and you can now use the knobs to adjust the
parameters.
3
Set the following parameter.
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
4
In the <Decay Mix Mode> group, select the way in which the video signal
is blurred.
Soft: mix the live image and the afterimage.
Hard: show the lighter of the live image and afterimage.
5
To erase the afterimage, press [Decay Eraser], turning it on.
Erasing the afterimages that remain in memory whenever a
keyframe is passed
Press [Decay Eraser], turning it on.
When the effect passes a keyframe, the afterimage is erased before writing a
new afterimage.
Selecting the freeze timing
In the <Decay Freeze Timing> group, select the timing for motion decay
freezing.
Frame: freeze in frame units.
Field: freeze in field units.
Applying stardust to the afterimage portion
The afterimage portion becomes stardust, and gradually disappears.
Knob Parameter Adjustment Setting values
1 Video Decay Degree of blurring of the video
signal
0.00 to 100.00
a)
To Next Page
Loading...
